Vac U Lock Adaptor Installation Guide for Theraguns

Press the adaptor onto the end of your massager, just as you would any of the stock adaptors that came with your Theragun. The circles inside the adaptor must line up with the outer metal bearings on your Theragun’s male end.

Once the adaptor is clicked into place, you can perpendicularly slide on the dovetail locking clip. Ensure both dovetail edges are in line on both sides before fully pressing it on.

When attaching the adaptor to your massager and when installing your toys be careful to not twist the adaptor side to side, keep any pressures applied to the adaptor and your toys nice and straight.

To remove, you can apply opposite directional pressure to the locking clip to slide it off.

NOTE:
1) Before starting up your massage gun, ensure that your toy or adaptor is braced with your other hand (as shown in video). This will help absorb some of the vibrations. This adaptor is not designed to be ran in the open air, as the vibes created from the Theragun are incredibly strong, however when slightly bracing the adaptor with your hand the vibrations are not fully absorbed by the adaptor.

2) If your locking clip slips off this means you may need to tighten its gripping strength. This can be done very easily by applying a little bit of heat to the tips of the clip “U” clip and pinching the tips inwards slightly.

We recommend using a hair dryer for 8-10 seconds. Once hot, gently pinch the tips inwards with your index finger and thumb. Allow your clip to cool for 3 minutes before installing again. This can be repeated many times to find the optimal tension.